We can supply Fyre jackets and all other products in the XRP range, please call or send us an email with your requirements.

SpeedShopUK has created this guide by reworking images and text that were originally downloaded from XRP

Step 1	Step 2
FYRE JACKET is easiest to install at the time of hose assembly. However, with a bitmore effort, itmay be installed onto an already existing hose assembly. Assemble one hose end and insert a threaded plug into the female end fitting.Wrap tape around the opposite end of the hose to prevent it fromsnagging the inside of the FYRE JACKET and keep any debris out of the hose during installation. Plug off both end fittings if covering a previously assembled hose.	Cut the FYRE JACKET to the proper length and slip it over the unassembled end of the hose or, if installing on an existing assembly, one of the plugged end fittings.
Step 3	Step 4
While a helper pushes the hose forward into the FYRE JACKET, he can grab the installed end of the FYRE JACKET and try to pull it toward him and onto the hose. USING GREAT CAUTION and with proper eye protection on both you and your helper, apply a VERY SMALL amount of compressed air into the open end of the FYRE JACKET while your helper continues to grab the FYRE JACKET and pull it onto the hose.The compressed air should be only sparingly applied to just slightly expand the FYRE JACKET and allow it to slide easily over the hose. DO NOT INFLATE THE FYRE JACKET as this could cause injury or death.	Center the FYRE JACKET on the hose using the compressed air under the FYRE JACKET, if necessary. Install the remaining hose end fitting if needed. Tape or seal the cut ends of the FYRE JACKET as needed to prevent any fluids fromwicking into the exposed fibers. Silver silicone FYRE TAPE, part no. 320200, is excellent for this protection.
Completed